
Privacy Fence Installation in Lansing, MI
Lansing Capital Fence puts up privacy fencing in Lansing, MI, and every job starts with what needs hiding, whether that's a neighbor's kitchen window or the hot tub on your patio. Every post is dug toward the 42-inch frost line, since a tall wall of boards is the fence that heaves first. Screens like these also go up in East Lansing, Okemos, Holt, Haslett, DeWitt, Grand Ledge and Mason.
Request a quote
Tell us why you want a fence and which yard it goes in. Someone calls you with a range.
The city limit states that behind the house, you can have a fence as high as six feet, but only three feet in front of the house. A few sections of some type of fencing around a patio would be far cheaper than fencing down the whole side of a house.
- Layout drawn to the 6-foot side and rear limit
- Front-yard sections held to 3 feet
- Corner lots measured for the 25-foot sight triangle
- Posts dug toward Michigan's 42-inch frost line
- Gate posts set heavier than line posts
Price a privacy fence
Typical prices per foot for Lansing jobs. Your quote follows a look at the job.
| Type | Per foot |
|---|---|
| Wood boards, 6 ft | $27 to $44 |
| Vinyl panels, 6 ft | $51 to $71 |
| Partial privacy, 4 ft | $30 to $55 |
| Composite | $55 to $85 |
$3,240 to $5,280
Call (517) 418-7986 for your priceAt a glance
| 6 ft wood boards | $27 to $44 per installed foot |
|---|---|
| 6 ft vinyl panels | $51 to $71 per installed foot |
| Composite boards | $55 to $85 per foot |
| Tallest in the back yard | 6 ft; 8 ft only with the Zoning Administrator |
| Corner lots | Nothing over 3 ft in the 25 ft sight triangle |
| Old fence torn out | $10 to $20 per foot |
Privacy Fence Layouts for Lansing Yards

Dog Yard Privacy Fence
We recommend a dog yard privacy fence that doesn't allow the dog to view passersby, so there is less barking going on in the neighborhood. You still have to follow the rules of three feet tall in the front, possibly four feet if you can see halfway through the top foot of that fence. The privacy fence should always have the gate swinging into the yard instead of out of your property.

Patio and Hot Tub Screen
A patio and hot tub screen should be a structure that covers only where you are sitting, either on the patio or in the hot tub. Even though this could be a smaller fence-type structure, the posts will still need to go full depth into the ground to ensure that the fence is stable and won't fall or lean on anybody.

Corner Lot Privacy Fence
Corner lots give up the most to the code. Lansing keeps anything taller than 3 feet out of a triangle measured 25 feet back along both streets from the corner, and out of a 10-by-10-foot triangle where a driveway meets the lot line. The tall run has to turn in before those points, so we mark them with paint before any digging.

Replacing an Old Privacy Fence
About three in four Lansing homes went up before 1980, so many yards already have a tired board fence. If yours is taller than today's limit or stands where a new one couldn't, mind how much you rebuild. The city lets a nonconforming fence be repaired and replaced in sections until half of it has been redone. Past that point, the new fence has to meet current rules.

Vinyl Privacy Fence
Tongue-and-groove vinyl panels skip staining for good, and plain water from the hose washes them. Lansing prices run $51 to $71 per installed foot, nearly twice what wood costs. We'd put vinyl where you'll stay a long time and never want to paint, and wood where the budget counts for more than upkeep.
More Ways to Get Privacy
Four-Foot Partial Privacy
It's the most screen a Lansing front yard allows, with lattice or spaced pickets across the top. 4-foot panels usually run $30 to $55 per foot.
Chain Link With Privacy Slats
Weave slats through chain link for the cheapest screen, usually $14 to $48 per foot. Out front the chain link must be vinyl-coated, since bare galvanized is banned in Lansing front yards.
Lattice Tops
A band of lattice on top keeps the view partly open and makes 6 feet of wall look lighter. The lattice counts toward the 6-foot limit. That leaves 5 feet for boards under a foot of lattice. It looks good over a hot tub.
Screens in Historic Districts
Lansing's Historic District Commission reviews exterior changes in its local districts. If your house sits in one, check with the Planning Office before ordering lumber. A week of waiting costs less than tearing out a new screen.
Composite Privacy Fence
Wood fiber bound with plastic and molded to pass for boards, with no staining. It costs more than vinyl, usually $55 to $85 per foot.
How Tall a Privacy Fence Can Be in Lansing
The zoning code in Lansing was rewritten in 2025 and states that you cannot have any piled-up dirt in order to gain height above six feet. If the ground you’re building a fence on is uneven, they will use an average natural grade height to determine six feet. Neighboring townships in the area typically have their own rules, but before building anything over six feet tall, always check with zoning, HOAs, your neighborhood, etc., because you don’t want to pay for an eight-foot fence only to have to take it down to six feet. There have been cases where an eight-foot fence is allowed, but it’s typically under special circumstances that need to be looked at. Be sure to get it in writing from the zoning official that more than six feet is legal on your property.
Building a Privacy Fence That Lasts Through Lansing Winters
Call MISS DIG 811
Michigan law asks anyone digging to contact it at least three business days ahead, and no more than 14 days ahead. Fence posts count. The service costs nothing. Lansing yards get trenched for gas line work, so lines aren’t always where the previous fence suggests.
Find the line before the layout
We look for the corner markers first. Where they’re gone, a survey settles it. We’d rather hold the posts slightly inside the line than start an argument with the neighbor on install day.
Dig for the frost
Frost reaches 42 inches by Michigan’s residential code, and Lansing’s airport logs roughly 142 freezing nights in an average year. Any post set well above that depth gets pushed up a little each winter. With solid boards, one heaved post drags a whole section out of line.
Set the gate posts heavier
A latch that quits a few weeks in usually means the gate post leaned or settled. Gate posts get a bigger hole and get checked for plumb before the concrete sets, and you tell us which way the gate should swing before it’s hung.
Let the footings cure
Concrete around a post takes 1 to 4 days to cure, less with quick-set. Rails and boards go on after that, never into wet concrete.
Keep the snow pile in mind
Snowfall here runs near 50 inches in a normal winter, and drifts lean on tall boards like a bulldozer blade. Keep the run off the strip where the driveway snow gets pushed.
Walk it together
Before the crew leaves, swing every gate and test every latch with you.
Wood or Vinyl, Repair or Replace
Wood boards or vinyl panels
Cedar boards on ground-contact treated posts cost about half what vinyl does up front, and a stained board fence fits Lansing’s older houses. Over the years the sums turn around. The lumber question gets a fuller answer under cedar and pine fence lumber.
We would choose the vinyl. Even though it costs more in the beginning, it will be much cheaper in the long run, because it will never need stain and will not rot out.
Fix the old fence or start over
Shove the top rail midway between two posts. If the fence rocks at more than a few posts, it’s worn out at the ground. Replacing five damaged posts costs about as much as a fresh 100-foot wood fence (see the cost table).
Privacy Fence Cost in Lansing
Six-foot wood boards cost $27 to $44 per installed foot in Lansing. A backyard of 150 feet comes to roughly $4,100 to $6,620 before gates. A 100-foot run comes to about $2,730 to $4,410 in wood and $5,100 to $7,120 in vinyl.
Most people build fences in summer, so that would be the busiest months, and it would be hardest to find a crew.
| Privacy fence | Per linear foot, installed | Where |
|---|---|---|
| Wood boards, 6 ft | $27 to $44 | Lansing |
| Vinyl panels, 6 ft | $51 to $71 | Lansing |
| Partial privacy, 4 ft | $30 to $55 | US |
| Chain link with slats | $14 to $48 | US |
| Composite boards | $55 to $85 | US |
| Old fence removal | $10 to $20 | US |
| Damaged post | $250 to $600 each | US |
The Lansing figures cover zip 48912 and 150 feet of fence, read in October 2026, assuming easy ground and 3-foot holes. Lansing’s frost line is 42 inches, and the deeper holes add labor. The US rows are national 2026 averages. Gates, a survey and any grading are extra.
What moves the price
- Run length. A crew’s setup doesn’t shrink with the fence, so the per-foot price climbs as the fence gets shorter.
- Corners and setbacks. Every turn the layout makes around a sight triangle or a driveway adds a corner post and its own deep hole.
- Gates. Every gate means a stouter post plus its own hardware. A double gate for a trailer needs two.
- Tear-out. Pulling the old run and hauling it off adds between $10 and $20 per foot. Posts buried in concrete push it toward $20.
- Slope. A fence follows the grade it’s on. Where the ground has to be leveled first, grading runs $500 to $3,000.
If the only thing to hide is a trash cart or the air conditioner, a store-bought screen panel on two posts does the job without a fence crew.
Get a quote on your privacy fence installation
Say what the fence has to do, which part of the yard it runs through and roughly how long it is. Expect a call with a ballpark figure, and the two or three things that would move it, like a corner lot, a second gate or old posts set in concrete.
Privacy Fence Installation in nearby areas
Privacy Fence Installation FAQs
How much is 100 feet of privacy fence in Lansing?
A six-foot wooden fence approximately 100 feet long is going to run about $2,730 to $4,410. A vinyl fence the same length is going to be about $5,100 to $7,120. The cost per foot goes up quite a bit for short runs, less than 100 feet. If you're going to have some fencing done, it's better to do it all at once, while the crew is there only one time.
Can a solid fence stand in my front yard in Lansing?
Yes, a solid fence can go in your front yard in Lansing. The front-yard limit is restricted to three feet tall. You can build a four-foot fence, but the top foot of that fence, from three to four feet, has to be half open for see-through purposes.
Can I build an 8-foot fence in Lansing?
All fences in Lansing, beside or behind the house, have to be six feet tall or less in almost all cases. There are certain conditions that may allow for an eight-foot fence, but it will require zoning approval from officials, and HOA restrictions apply if there is an HOA in your area. Be sure to get approval before building a fence eight feet tall.
Does a backyard fence need a permit in Lansing?
The state code states there is no permit needed up to 7 feet of fence. The city permit page states there's no fence permit required, but always check first and ask your fencing company, as they typically will know what needs a permit and what does not.
What if a storm knocks my fence over?
If a storm were to knock over your fence, we would recommend you fix it as soon as possible, before it counts as an unsafe structure on your property. If you leave the fence down for too long, there will be a notice, then a last warning, and then a fine. Be sure to get the fence up before the last warning.
Do I need a survey before the fence goes in?
Typically not, unless some corner markers are gone or there is a disputed line conversation going on with neighboring properties. Always check and make sure the lines are accurate, because moving posts that are already set costs more.
Request a quote
Ring (517) 418-7986 if you would rather talk now, or leave the details below and expect a callback.
